D9T Track-Type Tractor Power Train – Equalizer Bar – Disassemble

Disassembly Procedure

Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     5P-4758     Internal Pliers As     1    
B     6V-3175     Double Acting Cylinder     1    
3S-6224 Electric Hydraulic Pump Gp     1    
4C-9634 Puller Stud     1    
1P-0544 Fast Runner Nut Assembly     1    
4K-0684 Hard Washer     1    
1M-6756 Press Sleeve     1    
FT-2802 Bearing Puller Adapter     1    
C     6V-3175     Double Acting Cylinder     1    
4C-9634 Puller Stud     1    
3S-6224 Electric Hydraulic Pump Gp     1    
1P-0544 Fast Runner Nut Assembly     1    
1M-6756 Sleeve     1    
4K-0684 Hard Washer     1    
5P-7399 Bearing Puller Adapter     1    

Start By:

  1. Remove the equalizer bar. Refer to Disassembly and Assembly, “Equalizer Bar – Remove”.

    Note: The seals or the bearings on the equalizer bar can be removed in chassis by removing and lowering one side of the equalizer bar at a time.




    Illustration 1 g00802018

  1. Remove washers (5), seal (6), and seal (4) from the center of equalizer bar (7) .
  1. Remove seals (8) from both ends of the equalizer bar.
  1. Use Tooling (A) in order to remove lock rings (9) from both ends of the equalizer bar.
  1. Remove plug (1), O-ring seal (2), and grease fitting (3) .



    Illustration 2 g00803292

  1. Use Tooling (B) in order to remove self-aligning bearing (10). Remove the self-aligning bearing in the other end of the equalizer bar.



    Illustration 3 g00803293

  1. Use Tooling (C) in order to remove bearing (11) from the center of the equalizer bar.
Posted in D9Tagged