Removal Procedure
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | – | Guide Stud 3/8 -16 by 5 inch | 2 |
Start By:
- Remove the rear center bottom guard.
- Disconnect hose assemblies (1) and disconnect harness assembly (2) .
![]() |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
![]() |
|
|
|
|
Illustration 1 | g02673156 |
- Remove top two bolts (3) and install Tooling (A) . Remove remaining bolts (3) . Use two people in order to remove lubrication distribution manifold (4) . The weight of priority valve (4) is approximately 29 kg (65 lb).
Installation Procedure
- Install lubrication distribution manifold (4) in the reverse order of removal.