3306 DIRECT INJECTION VEHICULAR ENGINE WITH NEW SCROLL FUEL – Fuel Tank

Remove And Install Fuel Tank

1. Remove plate assembly (1).

2. Turn valve (2) for the fuel supply to the “OFF” position. Disconnect fuel line (3).

3. Remove two bolts (4) and tube (5) from the left side of the fuel tank.

4. Remove two bolts (6) from each side of the fuel tank. The bolts hold the fuel tank to the fenders of the machine.

5. Use a pry bar and move the fuel tank approximately 12.7 mm (1/2 in.) away from the operator’s platform to permit installation of a hoist.

6. Fasten a hoist to fuel tank (7). Remove the fuel tank from the machine. The weight of the tank is 135 kg (300 lb) empty.

NOTE: The following steps are for installing the fuel tank.

7. Fasten a hoist to fuel tank (7) and put it in position on the fenders of the machine. Make sure the bolt holes in the bottom of the tank are in alignment with the holes in the fenders. Install the four bolts that hold the tank.

8. Connect tube (5) to the left side of the fuel tank with two bolts (4).

9. Connect fuel line (3) to the valve on the bottom of the fuel tank. Turn the valve for the fuel supply to the “ON” position.

10. Install plate assembly (1).

Posted in D6Tagged