26SI Series Alternator – Electric Starting Motor

Remove And Install Electric Starting Motor

1. Remove the guard assembly on the right side of the engine.

2. Put identification on all the wires and cables connected to the starting motor for correct installation.

Later Machine Shown

3. Disconnect all wires and cables from electric starting motor (1).

4. Remove the three bolts and remove electric starting motor (1) from the engine. The weight of the starting motor is 70 lb. (32 kg).

5. Put electric starting motor and the gasket in position in the flywheel housing. Install the three bolts that hold the starting motor.

6. Connect all the wires and cables to electric starting motor (1). Tighten the terminal nuts to a torque of 20 to 25 lb.ft. (25 to 35 N·m).

Posted in D6Tagged