26SI Series Alternator – Alternator – Assemble

Assembly Procedure

Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.

    Note: Do not strike the diodes. The shock of such an impact can damage the diodes. Use proper tools in order to press the diodes in the mountings.




    Illustration 1 g00628072

  1. Install 3 diodes (11) in heat sink (12) .



    Illustration 2 g00628068

    Note: Do not strike the bushing. Shocks from striking the housing can cause damage.

  1. Press bushing (43) in housing (14) .
  1. Install 3 diodes (13) in housing (14) .



    Illustration 3 g00628067

  1. Press collar (42) on rotor (39) .
  1. Slide retainer (41) on rotor (39) .
  1. Press bearing (40) on rotor (39) .



    Illustration 4 g00628063

  1. Press housing (31) on rotor (39) and bearing (40) .
  1. Install 4 screws (38) in housing (31) .



    Illustration 5 g00628057

    Note: Do not strike the bearing. Shocks from striking the housing can cause damage.

  1. Install the inner race. Press bearing (37) into the housing.



    Illustration 6 g00628043

  1. Press cap (36) in housing (14) .



    Illustration 7 g00628041

  1. Install the coil and support (34) in housing (14). Guide the field leads and the grommet through the hole as the coil is installed in housing (14). Install 3 screws (33) .



    Illustration 8 g00628037

  1. Press the stator (32) and housing (14) together. Guide the stator leads and the grommet through the hole as the stator is installed in housing (14) .



    Illustration 9 g00628035

    Note: Do not damage exposed stator windings or field windings. Bumping the windings or scraping the windings may break the insulation. Broken insulation may create a short circuit or a ground.

  1. Join housing (31) and housing (14). Install 4 bolts (30) .



    Illustration 10 g00627853

    Note: Many of the alternator’s internal components are covered with dielectric grease. If the grease is removed, reapply the grease.

Posted in D6Tagged