Separation Of Tracks The adjuster cylinder for the track is under high hydraulic pressure. Do not visually inspect the relief valve to see if grease…

NOTE: For instruction on reusability, see Guidelines for Reusable Parts; Sealed and Lubricated Track, Form No. SEBF8022. Maximum track press assembly force … 400 ±…

Remove And Install Track Rollers 1. Make an adjustment to tooling (B) until the height is approximately 108 cm (42.5 in.). Make an adjustment to…

Remove Track Carrier Rollers The adjuster cylinder for the track is under high hydraulic pressure. Do not visually inspect the relief valve to see if…

(1) Diameter of shaft … 63.00 ± 0.03 mm (2.480 ± .001 in) (2) Torque for bolts … 55 ± 7 N·m (41 ± 5…

9S2730 3T3206 (1) Assemble shaft even with the back of the bracket. Make an adjustment if necessary for track alignment. (2) Rubber toric seals and…

Remove And Install Recoil Springs Start By: a. remove hydraulic track adjusters 1. Remove two bolts (3) from each stop (1). Remove the stops from…

Remove And Install Hydraulic Track Adjusters 1. Make an adjustment to tooling (B) until the height is approximately 108 cm (42.5 in.). Make an adjustment…

Remove And Install Front Idler Yokes Start By: a. remove front idlers 1. Remove guards (1) and (2). 2. Remove two bolts (3), lock (5)…

Remove And Install Front Idlers Start By: a. separation of tracks 1. Remove bolts (2) and guard (1) from each side of the front idler.…